Counterbore Dimensioning

website counterbore slot callout -Change the M4 thread to a counterbore with a 50 depth -Open the drawing, both existing hole callout have not updated correctly, so re counterbore slot -Change the M4 thread to a counterbore with a 50 depth -Open the drawing, both existing hole callout have not updated correctly, so re

counterbore slot callout Specifies a callout for a slot that enters one surface and exits the next surface The available attributes are Size, Depth, Counterbore Size, Counterbore  A: Dimensioning a counterbore involves specifying its diameter and depth, along with the dimensions of the smaller pilot hole beneath it These  or if not, what is a better way to make the callout? Should I lay a center mark on the curved slot center, give it a radius dimension,

Share

Share

Link

Turn off sharing Copy link

See all details