Fillet weld or slot and tab??

Fillet weld or slot and tab?? tab and slot weld The size of the weld will be the slot width instead This is shown to the left of the symbol just as it is shown in plug welds image 12” width slot weld The tab and slot weld bars and run-off tabs are required to be removed and repaired penetration groove welds with backing, intermittent groove welds, plug and slot welds and

tab and slot weld My usual practice is when I make a sheet metal design I would add tab and slot for ease of welding and ensure the plate positioned at desired

tab and slot joint Hi, I'm a newbie trying to design a welding fixture table in solidworks, and I have a couple of tab & slot questions I'm hoping someone can Plug welding the tab into the slot allows for fast assembly and ease of welding Plug welding can be used at the tabs that fit into the slots